|
Specifications |
| IAPMO Listed --
Not intended for continuous use |
| EPDM
packing to prevent leaking |
| Oval, powder-coated, die cast
aluminum handle |
| Stainless steel seat
- eliminates wire draw |
| Adjustable wall flange |
| Standard “O” size seat washer |
| Tee Key configuration
- (extra charge) |
| No-lead solder |
| 3/4” male hose thread |
|
MAX PRESSURE - 125
p.s.i. |
|
MAX TEMPERATURE - 120°
F |
INSTALLATION REQUIREMENTS:
• The faucet length used is to be
comparable to what would be used with standard freezeless faucets.
• The inlet connection must be located in a heated area.
• The gap between the house and faucet must be sealed to prevent air
leaks
• The faucet must be installed with a slight downward pitch toward the
nozzle.
• Adequate insulation is required around the faucet, wall board and sill
plate. |
|
Warranty
All Model 16 Wall Faucets are sold with a limited
warranty for fi ve years against defects in material and workmanship. We
will replace or issue credit (at our option) for defective goods that
are returned for inspection and found to be defective within fi ve years
of purchase from Woodford. In addition, Woodford will pay up to $5,000
toward the cost to repair damages incurred as a result of a defective
Model 16 Wall Faucet that was properly installed. This limited warranty
does not cover defects caused by: modifications, alterations or repair
of the product by anyone other than Woodford; physical abuse to, or
misuse of, the product or operation thereof in a manner contrary to the
accompanying instructions. |
|
U.S. Patents:
Manufactured under one or
more of the following patents: 3,208,715; 3,278,201;
5,590,679;5,632,301; 5,632,303; 6,142,172; 6,206,039B1; 6,532,986 and
patents pending |
|
Warning - Faucet must
be installed with downward pitch toward nozzle.
This product is
tested and listed to an ASSE standard. The standard states that this
product is not intended to be used for over 12 hours of continuous use. |
Please contact your authorized Woodford
Representative for information on placing an order.
Specify model number, inlet and wall thickness
|
